Pocket Door Hardware Instructions

Install finished jambs split header and casing as shown.

Pocket door hardware instructions.

Most are under 100. Pocket door frame set is designed for use with doors up to a maximum of 80 in. Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased. Fasten split header on 1121 lock lever side with screws for future door removal or adjustment.

If needed use a hand saw to cut the track that came with your pocket door hardware so that it s 1 8 inch shorter than the opening. Once the frame is in place it s time for the pocket door installation. Prime line 2 pack 1 125 in plastic pocket door bottom guide. High and 1 3 4 in.

Attach the split studs to the floor and to the header checking for plumb. Its door panels are adjustable up to 5 8 in. Répétez l opération avec l autre roulette et attache de porte. Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw.

Do not use jambs with dado s. Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives. Higher than the door panel height. You may be able to find pocket doors at lumberyards too.

Step 1 read the directions. Nail the end plate to the wall studs. The door rides through a channel made by what are called split studs these studs function like regular wall studs but are metal wrapped and form a hollow channel in the middle for the pocket door to pass through. The everbilt 36 in.

Bumpers pads slides door hardware home hardware household hangers knobs pulls. 1 574 293 5664 m f 8 00am 5 00pm est. Johnson hardware pocket door hardware. Purchase a pocket door kit at a hardware store.

Check that the track is level so that the door rolls easily. Vertically and the door rough opening should be 4 in. Door hardware knobs pulls supports catches latches all categories. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door.

Pocket door frame set the everbilt 36 in. This kit should contain the door split studs that allow the door to retract into the wall a track on which the door runs into the wall and door hardware.