Diagnose power door locks don t work properly.
Power door lock not working on 2008 dodge ram.
Posted on sep 25 2008.
I took the wire harness out and tested it and it works fine.
Usual cause the power door locks utilize individual solenoids in each of the doors that activate the door lock mechanism.
All the switches on all four doors will not work either.
Could be the issue or the relay it self is bad.
Power door locks do not work.
Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob.
The switch provides power to the door lock solenoids.
The most recently reported issues are listed below.
Symptom summary the power door locks are all inoperative or a single door lock is inoperative.
Dodge ram 1500 owners have reported 2 problems related to power door locks not working under the electrical system category.
It runs off a 5 volt reference.
The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators.
What a forked up way to build stuff.
Windows can still work but locks will all stop.
The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working.
I read in a forum that it could be the relay that has a 25a fuse in it that.
The most recently reported issues are listed below.
My power windows on a 2008 dodge ram 1500 will not close.
21 people found this helpful.
Even if you change the acuators the locks still will not work until the code is cleared.